Date: 12 March 2019 Time: 4.00 p.m. Location: BAP We met Dr. Hakimin after the class in order to pay for our Robomaker Kit. The kit consist of: a BBC micro:bit board (batteries included) a couple of servo motor and wheels battery pack male to male jumper wires wire clip connector alligator clip After the […]

Title: Lab Conduct 1 Date: 18 March 2019 (Monday) Location: Bengkel Teknologi Bahan Today, we started the experiment by: Shredding the Styrofoam block into smaller parts in order to increase the contact surface area thus reducing time needed to dissolve the Styrofoam. We also sieved the sawdust in order to break up clumps and separate […]

Title: Lab Conduct 2 Date: 26 March 2019 (Tuesday) Location: Bengkel Teknologi Bahan Today, we started the experiment by: Measuring 200 ml of toluene that we obtain from Material Technology Laboratory. We also weighed about 200 g of Styrofoam and mix it with the toluene in order to dissolve it. After that, we also weighed […]

Title: Lab Conduct 3 Date: 27 March 2019 (Wednesday) Location: Bengkel Teknologi Bahan Today, we started the experiment by: Measured 50 ml of epoxy and 5 ml of MEKP as the hardener. After that, we also weighed the sieved sawdust for about 5 g and mix the the sawdust with the epoxy and MEKP. The […]

Title: Lab Conduct 4 Date: 31 March 2019 (Sunday) Location: Bengkel Teknologi Bahan Today, we started the experiment by: Measured 50 ml of PE resin and 5 ml of MEKP as the hardener. After that, we also weighed the sieved sawdust for about 5 g and mix the the sawdust with the epoxy and MEKP. […]

Title: Lab Conduct 5 Date: 11 April 2019 (Thursday) Location: Bengkel Kayu Today, we started the experiment by: Measured the width, length and height of each samples. After that, set up the universal testing machine for the tensile test. The sample was placed in the between the grips and kept in place by tightening the […]

Title: Chassis Assembly Process Date: 28 April 2019 (Sunday) Location: Bengkel Kayu The boards produced from sawdust and polyester resin are cut into pieces using hacksaw. The pieces are trimmed and sanded in order to produce smooth and well fit surface. The pieces are assembled together using metal L brackets to create sturdier structure for […]

Title: Coding Process Date:  30 April 2019 (Tuesday) Location: IBS UMK Wiring Process: Connect “0” edge connector to the control signal of the left servo motor. Connect “2” edge connector to the control signal of the right servo motor. Connect “Gnd” edge connector to the negative wire of the 4 pack battery slots. Ground wire […]